KONFIGURASI ANTAR VLAN
1. Buatlah topologinya
terlebih dahulu
2. Buat IP Address Disetiap PC
IP PC4 dan
PC5 = 192.168.1.0/24
IP PC6 dan
PC7 = 192.168.2.0/24
3. Buat vlan name di switch
Switch#conf
t
Enter
configuration commands, one per line.
End with CNTL/Z.
Switch(config)#vlan
10
Switch(config-vlan)#name
Switch(config-vlan)#name
10
Switch(config-vlan)#ex
Switch(config)#vlan
20
Switch(config-vlan)#name 20
Switch(config-vlan)#ex
Switch(config)#ex
4. Daftarkan port vlan id
Switch#conf
t
Enter
configuration commands, one per line.
End with CNTL/Z.
Switch(config)#int
range fa0/1-2
Switch(config-if-range)#sw
m acc
Switch(config-if-range)#sw
acc vlan 10
Switch(config-if-range)#ex
Switch(config)#int
range fa0/3-4
Switch(config-if-range)#sw
m acc
Switch(config-if-range)#sw
acc vlan 20
Switch(config-if-range)#ex
Switch(config)#int
fa0/5
Switch(config-if)#sw
m tr
Switch(config-if)#ex
5. Connectkan vlan 10 dan vlan 20
Router>en
Router#conf
t
Enter
configuration commands, one per line.
End with CNTL/Z.
Router(config)#int
gi0/0
Router(config-if)#no
sh
Router(config-if)#
%LINK-5-CHANGED:
Interface GigabitEthernet0/0, changed state to up
%LINEPROTO-5-UPDOWN:
Line protocol on Interface GigabitEthernet0/0, changed state to up
Router(config-if)#
Router(config-if)#ex
Router(config)#interface
gi
Router(config)#int
gi0/0.10
Router(config-subif)#
%LINK-5-CHANGED:
Interface GigabitEthernet0/0.10, changed state to up
%LINEPROTO-5-UPDOWN:
Line protocol on Interface GigabitEthernet0/0.10, changed state to up
Router(config-subif)#encapsulation
dot1Q 10
Router(config-subif)#ip
address 192.168.1.1 255.255.255.0
Router(config-subif)#ex
Router(config)#int
gi0/0.20
Router(config-subif)#
%LINK-5-CHANGED:
Interface GigabitEthernet0/0.20, changed state to up
%LINEPROTO-5-UPDOWN:
Line protocol on Interface GigabitEthernet0/0.20, changed state to up
Router(config-subif)#encapsulation
dot1q 20
Router(config-subif)#ip
add 192.168.2.1 255.255.255.0
Router(config-subif)#ex
6. Terakhir coba test ping atau kirim pesan
~SELESAI~
Komentar
Posting Komentar